The Doherty amplifier is a modified class B radio frequency amplifier invented by William H. Doherty of Bell Telephone Laboratories Inc in 1936. In Doherty's day, within the Western Electric product line, the eponymous electronic device was operated as a linear amplifier with a driver which was modulated. In the 50,000 watt implementation, the driver was a complete 5,000 watt transmitter which could, if necessary, be operated independently of the Doherty amplifier and the Doherty amplifier was used to raise the 5,000 watt level to the required 50,000 watt level.
The amplifier was usually configured as a grounded-cathode, carrier-peak amplifier using two vacuum tubes in parallel connection, one as a class B carrier tube and the other as a class B peak tube (power transistors in modern implementations). The tubes' source (driver) and load (antenna) were split and combined through + and – 90 degree phase shifting networks [1]. Alternate configurations included a grounded-grid carrier tube and a grounded-cathode peak tube whereby the driver power was effectively passed-through the carrier tube and was added to the resulting output power, but this benefit was more appropriate for the earlier and less efficient triode implementations[2] rather than the later and more efficient tetrode implementations[3].
As successor to Western Electric Company Inc for radio broadcast transmitters, the Doherty concept was considerably refined by Continental Electronics Manufacturing Company of Dallas, TX.
Early Continental Electronics designs, by James O. Weldon and others, retained most of the characteristics of Doherty's amplifier but added medium-level screen-grid modulation of the driver (317B, et. al.).
Perhaps, the ultimate refinement was the high-level screen-grid modulation scheme invented by Joseph B. Sainton. The Sainton amplifier consisted of a class C carrier tube in parallel connection with a class C peak tube. The tubes' source (driver) and load (antenna) were split and combined through + and – 90 degree phase shifting networks as in a Doherty amplifier.
The unmodulated radio frequency carrier was applied to the control grids of both tubes. Carrier modulation was applied to the screen grids of both tubes but the screen grid bias points of the carrier and peak tubes were different and were established such that the peak tube was cutoff when modulation was absent and the amplifier was producing rated unmodulated carrier power and both tubes were conducting and each tube was contributing twice the rated carrier power during 100% modulation as four times the rated carrier power is required to achieve 100% modulation. As both tubes were operated in class C, a significant improvement in efficiency was thereby achieved in the final stage. In addition, as the tetrode carrier and peak tubes required very little drive power, a significant improvement in efficiency within the driver was achieved as well (317C, et. al.).[4] The commercial version of the Sainton amplifier employed a cathode-follower modulator, not the push-pull modulator specified in the patent, and the entire 50,000 watt transmitter was implemented using only nine total tubes of only four tube types, a remarkable achievement.